氫氧化鉀的工藝生產保障要點有什么？提前了解好這方面的內容，您才能更加更加順利的去進行使用操作，下面小編為您講解一番相關內容吧。

What are the key points of process production guarantee for potassium hydroxide? If you know this content well in advance, you can use it more safely and smoothly. Let's explain the relevant content for you.

檢查產品部分變質的時候可以通過往當中加入進去過量氫氧化鉀一直等到完全沉淀，等到沉淀已經靜止之后取上層的清液放置在試當中，然后往當中滴加無色的酚酞溶液，如果酚酞變紅了那么就說明當中是有堿性物質的。

When checking whether the product is partially deteriorated, you can add excessive potassium hydroxide into it until it is completely precipitated. After the precipitate is still, take the supernatant of the upper layer and place it in the test, and then drop a colorless phenolphthalein solution into it. If the phenolphthalein turns red, it means there is alkaline substance in it.

1、保證加氫反應和氧化反應工作液的pH值。蒽醌法生產雙氧水時，工作液的加氫是在堿性條件下進行的。加氫液的氧化反應和雙氧水的萃取需要在酸性條件下進行。當氧化液變為堿性時，雙氧水會引起事故。

1. Ensure the pH value of hydrogenation reaction and oxidation reaction working solution. When anthraquinone method is used to produce hydrogen peroxide, the hydrogenation of working solution is carried out under alkaline conditions. The oxidation reaction of hydrogenation solution and the extraction of hydrogen peroxide need to be carried out under acidic conditions. When the oxidation solution becomes alkaline, hydrogen peroxide will cause accidents.

2、改進堿處理工藝。當堿處理過程出現異常時，氣體會帶出塔內部分堿液。如果分離器沒有完全分離，工作液的堿度可達正常指示值的數百倍。

2. Improve the alkali treatment process. When the alkali treatment process is abnormal, the gas will take out the alkali liquor inside the tower. If the separator is not completely separated, the alkalinity of the working fluid can reach hundreds of times of the normal indicated value.

3、嚴格控制氧化廢氣中的氧含量。氧化廢氣含有可燃氣體。在制造過程中，混合廢氣中的氧濃度會超過百分之15，可形成爆性氣體混合物。因此，嚴格控制廢氣中的可燃氣體和氧氣含量是我們認真考慮的問題。生產中一般用氮氣稀釋氧化廢氣，氧含量控制在百分之十以下。

3. Strictly control the oxygen content in oxidation waste gas. The oxidation waste gas contains combustible gas. During the manufacturing process, the oxygen concentration in the mixed exhaust gas will exceed 15%, which can form explosive gas mixture. Therefore, strict control of the combustible gas and oxygen content in the exhaust gas is a serious consideration. In production, nitrogen is generally used to dilute the oxidation waste gas, and the oxygen content is controlled below 10%.

擴展：氫氧化鉀急救措施

Extension: first aid measures for potassium hydroxide

皮膚接觸：立刻用水沖洗少15分鐘有條件的用弱酸清洗傷口（如醋酸、硼酸）。若有灼傷，就療。

Skin contact: immediately wash with water for at least 15 minutes. Conditionally wash the wound with weak acid (such as acetic acid and boric acid). If you have burns, treat them.

眼睛接觸：立刻提起眼瞼，用活動清水或生理鹽水沖洗少15分鐘。或用3%硼酸溶液沖洗。就醫。

Eye contact: immediately lift the eyelids and wash with active water or physiological saline for at least 15 minutes. Or rinse with 3% boric acid solution. Get medical attention.

吸入：疾速脫離現場空氣新穎處。必要時停止人工呼吸。就醫。

Inhalation: quickly leave the scene to the fresh air. Stop artificial respiration if necessary. Get medical attention.

食入：患者蘇醒時立刻漱口，口服稀釋的醋或檸檬汁，就醫。滅火辦法：霧狀水、砂土、二氧化碳。

Ingestion: Rinse mouth immediately when the patient wakes up, take diluted vinegar or lemon juice orally, and seek medical advice. Fire extinguishing method: fog water, sand, carbon dioxide.

由于該產品的特殊性我們每個人都一定要留意氫氧化鉀運輸和貯存期間，做一些維護工作，永遠不要直接接觸。在運輸過程中，一定要提早采取預防措施，以應對突發狀況。更多相關內容就來我們網站http://m.wenping365.com咨詢！

Because of the particularity of this product, everyone must pay attention to the transportation and storage of potassium hydroxide, do some maintenance work, and never contact it directly. During transportation, preventive measures must be taken in advance to deal with emergencies. Come to our website for more relevant content http://m.wenping365.com consulting service